Graphics kits, built for the RON.
Pre-cut vinyl wrap kits made specifically for Surron frames. No trimming, no stretching over panel lines — just peel, align, press.
Press, squeegee, ride.
No heat gun required. Most riders finish a full kit in under 30 minutes.
SIDE PANEL
SWINGARM
FENDER
Clean the panels
Degrease each panel with the included alcohol wipe. Dry fully before unpacking the vinyl.
Align with the guide marks
Each piece carries a registration notch matched to your model's bolt holes and panel lines — line it up, no measuring.
Squeegee outward
Work from centre to edge in straight passes. The air-release liner pushes bubbles out through the backing.
Peel and ride
Remove the transfer layer at a low angle. Cured and rain-ready in under an hour.
Fitted and rated.
4.9 average from 280+ verified UK orders.
Didn't expect a vinyl kit to line up this precisely around the swingarm bolts. Looks like a factory wrap.
Took about 25 minutes, bubble-free. Way better finish than the kit I bought off eBay last year.
Survived a full winter of trail riding with zero lifting at the edges. Ordering a second colourway for my mate's Ultra Bee.